top of page

Boeing 737 Motorised Throttle5

This page is split into three main sections:

Parts Guide

Print Guide

Build Guide

The ultimate printer I can recommend is the Bamboo Labs X1 carbon with AMS if you have deep pockets. ($1200). It's a massive leap forward in 3D printing, with excellent quality and impressive speeds. Its pretty much press print and go as the software and hardware do the calibration before each print. This printer will not manage the larger parts and you are going to need the  CREALITY CR10 v3, which is my second choice of printer.

pilot sign get here.png
737 SINGLE YOKE HEAD.jpg

Here's a helpful guide on using Prosim software to control electronics and converting steppers to Servo movements with Mobiflight. For instructions on programming and operating PMDG, check out the separate guide created by Bjarne Bracke.

General Information:

Pilot Spanner.jpg

Build Guide

Build Guide
bottom of page