Hi Karl and fellow sim builders,
I have purchased the 38mm steel required for the frame. On the parts list it says two lengths at 666mm and 1 length at 1162mm. On the drawing it shows two lengths at 700mm and 1 length at 1162mm. Can anyone who has finished there build, advise me on what is the correct length of the two uprights 666mm or 700mm?
Thank you
Andy
Thanks Karl
No delay as only put post up this morning and to be honest I didn't expect a reply from you as thought you would be unavailable due to travelling etc.
Thanks for the info, me being a bit thick I suspect but didn't want to cut it too short as that would be costly!!!
Bet your looking forward to an English pint!!!
Cheers
Andy
Hello Andy, I think im qualified to answer this one. I have attached the drawing below. The actual height is 666mm which would be cut to length from stock. The overall height with the base frame included is 700mm.
The 666 is shown left, and the 700mm is shown right.
I hope that helps, and sorry for the delay, I am only just getting back up and running while I wait for our stuff to arrive. Kind regards Karl