Hey again
in step 1, you are referring to noggins - are there threaded inserts? if so they are not in the BOM
in step 9, there is reference to M4 35mm but they are not in the BOM
in step 11 there is no screw type
in the BOM in the screw types, there is a typo - M4 x 20QTY 2 should be M4 x 20mm (QTY 2) - and there is only one of these in the instructions?
and there is a M4 x 25mm (QTY 1) which is not in the instructions, is that the one for the yoke?
corrected thank you
one more - the QTY on the bevel gear is 3, shouldn't it be 2?
and there is a M4 x 25mm (QTY 1) which is not in the instructions, is that the one for the yoke?
That was the screw missing in step 11.
in the BOM in the screw types, there is a typo - M4 x 20QTY 2 should be M4 x 20mm (QTY 2) - and there is only one of these in the instructions?
Corrected, Thank you
in step 11 there is no screw type
Corrected, Thank you
in step 9, there is reference to M4 35mm but they are not in the BOM
Added, Thank you
Hi, Noggins are the 3d printed alignment parts:
There is no need for these to be in the build guide, but they are in the print guide.