I found someone with a larger printer and had them print the cut guide for the main panel and the pieces of the glare shield. I paid a little for it, but it wasn't that much in the grand scheme of things (encoders, wire, switches, screws, display panels, etc.)
Hi @jsureke,
I printed these panels on the ender 3 v2.
I used Cura to generate the STL files and I left the models in a vertical orientation but rotated them to a 45* angle.
I also minimised the layer lines to 0.1 (this is not required as it takes quite a bit longer to do this but in my opinion it is worth it).
Finally I set the build to use the raft adhesion method to keep it stable throughout the build and I changed the support placement to be "everywhere".
The rest of my settings where the same as @Karl Clarke's on the build guide page.
I hope this helps you if you need to reprint anything, or anyone else who is just attempting the print.
I found someone with a larger printer and had them print the cut guide for the main panel and the pieces of the glare shield. I paid a little for it, but it wasn't that much in the grand scheme of things (encoders, wire, switches, screws, display panels, etc.)