Hi All, Can I get some help with the MTU Hall sensors? IE, Is it just a solder type connection to those terminals...Also Karl mentioned to set Hall sensor to correct position before finishing build.. How is this actually done....Also need final wire diagram.THANKS
top of page
bottom of page
I found that the easiest way to set up an hall sensor is to connect to 5 volt and adjust to you have 2.5 volt on the output. Do not forget to set handles in mid position before install
Hi John,
The wires are first wrapped around the pins in a hook shape and the soldered to the pins of the Hall sensor.
As for the final WD, yet again the move interfered with that part of the design. The last updated version is in the build guide MTU 5. It shows how a single stepper is connected to the arduino. This would need repeating for all the steppers.
As soon as the Throttle arrives back here, i will finish the build videos and WD with all settings. All the main info is on main desktop computer still in Brunei right now.
Kind Regards Karl.
Hi John. I posted similar question about a month ago. For me, I have the solder type too. I connected mine to a Leo Bodnar card. It acts like a game controller. Then you can configure the axis. If you go the Bodnar route, this is what they provided for connection.
VCC connects to +5V and OUT - to any analog input 1 to 8.
Here's my thread on similar question.