Anybody else battling to print L24 Speed brake guide for the MTUv5? It seems the skirt only goes around 2 parts of the model and layer 1 only prints part of the structure and not any support for layer 2. That means that layer 2 starts printing mid-air on the mid section and outer sections. I have checked all my settings, support is on everywhere as well. If you have found a way around it or any other advice it will be appreciated.
top of page
bottom of page
I think there is the same issue with L29. To fix this issue (fast and dirty) I just lowered the model in Cura until it touches the buildplate. In this case it was Z - 0.33mm.
Hi Karl. Thank you so much for rectifying it. I thought it was something I was doing wrong until I played the layers 1 by 1. Sorry, never got to send you a pic but I'm glad you picked it up in the end. I was actually surprised nobody else picked it up and checked the posts first to see if there was something about it. Thanks for the great support.
The files can be found here:
Kind Regards Karl.
Hello George, I had already corrected this and for some reason had not uploaded the latest version. the files now stand at V8. You can now see the skirt goes all the way around and there is no step.
Okay, I take all that back and you are completely right! That's never going to print well! and i am surprised no one else has mentioned it.
Good morning George,
I am looking into this now, But i am a little unsure what you mean? Do you have a screen shot of cura or a photo? L24 is a pretty simple part to print and should offer no issues.....