Logan, I use my MTU as a stand alone unit, but use HCSCI (previously SimVim) as the interface. It is just so much easier to configure. Just one Arduino Mega and there is still a lot of pins open to add a few switches and LED's. I use the MCP as well on the same board (also stand alone) The motorized part of the A/T, speed brakes and trim is not operational at this stage, but I'm working on it. 😃
Logan, I use my MTU as a stand alone unit, but use HCSCI (previously SimVim) as the interface. It is just so much easier to configure. Just one Arduino Mega and there is still a lot of pins open to add a few switches and LED's. I use the MCP as well on the same board (also stand alone) The motorized part of the A/T, speed brakes and trim is not operational at this stage, but I'm working on it. 😃