Hi Karl,
Hope your well and settling in to your new life in the UK!
I have a slight issue with my throttle. I have attached mages but basically the center rubber strip does not fit. It is at least 5mm too wide. Have I done something wrong??
Many Thanks
Andy
Thank you so much, Being printed as I type.
The adjusted design:
Hi Karl,
That would be great if you could but only if its not too much trouble. I think i would prefer TPU printed rather than an inner tube.
Much appreciated.
Regards
Andy
Hi Ede,
Thanks,ill give that a go. I thought I had put the whole thing together wrong and that's why it didn't fit!!
Andy
As a substitution, i used an old Bicycle Rubbertube and cutted three Stripes of the right Size out. 2-3mm overlapping at the Levers. That works for me.
Piki