Hi all,
I have started printing the parts for the 737 throttle. Where the instruction deem it better to use a 0.2 nozzle I had did so but the surface prints rough. I am hoping that this will be a setting I am missing somewhere in Cura but would love some help if possible,the slicer I am using is Ultimaker Cura.
Many thanks in advance,
Gary
I have a Ender 3 Pro. Wondering if I can print the MCP panels using something faster then the 11 hours Cura says it will take with quality set at .20, and a .20 nozzle. I am thinking about perhaps .20 quality but perhaps .40 or .60 nozzle.
Also I noticed a couple of comments about some of the electronics won't work with X Plane 11. I can get FS2021 due to slow internet speeds here in West Virginia. Thanks
Hi Karl,
So do you suggest for the throttle side plates and levers we use decals instead of 3d print?
Many thanks
Gary
Hi Gary, that does not sound right? Instead of printing a whole part, create a small circle in fusion to test print. Try switching ironing top surface on too. Let me know how you get one. The option is to ditch the 3d printed text, use a 0.4mm nozzle or bigger and used the decals instead. Kind Regards Karl