I am using MobiFlight but I have had to identify every wire and every pin before conecting to de pbc because I was unable to use de INFO log level.
I always have the "No config Found" information on debug level logging because if I choose info level nothing happens.
I configure buttons and encoders using event based MSFS2020 HubHop.
I am missing something????
Hello,
Yes, I think you may be missing something. List the components in the device list first. You must know if the wire is to an LED or Button. Place Mobiflight into debug mode.
Then for a button, press it, and it should report button 3 pressed. If there is no current event listed, it will say no config found. This is normal.
The same for an led. Write a line on the front output config tab of Mobiflight, and name it test. Then on the config page, select led 1, press test and write down which one lights up. Change to led 2 and repeat.
There are several videos on youtube that I show how this is done, but I honestly can not remember which ones.
Kind regards, Karl