Hi all
Anyone else come across this? I am getting gaps in the MCP text.
I have my Cura setting tuned to the recommendations on the building guide.
PLA+ @ 190 (was tested as best temp as per temp calibration tower), bed 65
esteps are calibrated correctly.
Hi Luke, sorry but that looks like under extrusion to me, I have made many of Karl’s MCP panels and haven’t had an issue. Even the main panel before the text looks the same. I would check your settings again, I tend to use nozzle temp 200 degrees and bed 60 with extrusion speed 100 my esteps are 98 and print speed 40 .
Hope this helps.. Mike