I’m having trouble figuring out how to attach the button pieces (letters and numbers) to
the led switches. There’s an upgraded base for the laser cut buttons which makes sense. What I can’t tell is how that piece is supposed to attach to the actual button. There’s a round hole that doesn’t seem to meld with the square top of the buttons.



Oh, and I just stabbed my finger with one of the tangs on the switch so now I’m frustrated because that hurt!
@Karl Clarkethank you for that. i wonder if my button bases are printing correctly. to me the holes seem round (see my pictures above). We're talking about the same piece, right?
Next use a flat bladed screwdriver (small) to squeeze the other tang in. Then push the whole button into the cap
Slide on leg into the rectangle orifice at the rearlike shown above