Hello can anyone tell me how do I create a breakout board? I have karl seen using them in his mip
top of page
To see this working, head to your live site.
Edited:Â Aug 29, 2021
How do I create a breakout board
How do I create a breakout board
6 answers1 reply
Like
7 Comments
bottom of page
https://www.amazon.co.uk/keyestudio-Prototype-Arduino-Double-Starter/dp/B07H3TFH1H/ref=sr_1_10?crid=157VL1VYRWMU1&keywords=keystudio+prototype+board+mega&qid=1663220014&sprefix=keystudio+prototype+board+mega%2Caps%2C94&sr=8-10
I use these all the time now
The ones I have seen (and use) are kits or preassembled units. They provide you with terminal blocks for all of the connections to the Arduino boards. That lets you insert a bare wire end into the block rather then needing to get a pin connector attached to the end of each one. They have them readily available on Amazon and I am sure eBay has them as well. The one shown below sells on Amazon for $17.90 and is kit form (see 2nd picture). Those black connecters have long pins that extend out the bottom and plug straight into the Arduino Mega board. The item shown is manufactured by Electronics Salon if you want to look it up.
I hope that information is helpful.