Anyone know what would cause this issue? There are sections where the layer is thicker. I've had it on a couple of builds but not in the same layer.
I wrote about the Ender-3 gantry in regards to "Elephant's foot" in my blog here, check it out it might be affecting you but in a different way @Steve Parrilla. In any case it is some gantry philosophy that might be useful. https://thingwizard.wordpress.com/2021/03/22/getting-rid-of-the-elephant-on-the-plate/
Hi Steve,
If you have a CR10, check the axes for play. Tighten the wheels that run on the guides. That's usually the cause for my printers.
Kind regards Karl