Hello,Has anybody printed the yoke with a 0.8mm nozzle 0.2 height? what is the resulting quality and does it pass muster?thanks in advanceDan
H Karl thanks for the reply I was going to print at 0.2 height and 0.88 width and print speed 40? I'm using the creality cr10 pro. I will test and let you know the results.
Hi Dan,
and yes I have. There is several issues:
1) The finish is nowhere near as good as a 0.4mm nozzle
2) If you dont calibrate your printer for a 0.8mm nozzle and change your settings, The parts will ahve a bad fit and a lot of sanding will be needed.
The good part is that it changes from a days print to literally hours!
Please let me know how you get on!
Kind Regards Karl