Quick question that I am sure will be answered quickly!
This rotary switch has all the positions and what not, but the middle doesn't look the same as the wiring diagram/instructions for the MCP build. Would this still work?
Thanks in advance to everybody.
I have used these on both my $38 MCP and my EFIS v4. The pin allows you to lock them in from 2 to 12 positions. They are 30 degrees between stops. If you look closely at the images in the link you sent, you will notice there are three pins in the center (A, B, and C). The only active pin is A. The B and C pins have been ”broken” off. The center “A” pin would be the common.