Hi there,I'm building the yoke, I don't understand where or how the spring is attached to the 737 Single Control Head.On the drawing the feather hangs in the air.can someone help me?
I am looking at your "Boeing 737 Single Yoke Control Head" design and I couldn't see any provision to pass through the head any cable from the Yoke to the column (elevator trim, push to talk, A/P Disengages, etc.).
Hey attached the spring to a 4mm Threaded Bar, which is attached into the middle of the Control head. I just make a 4 mm hole on both sides of the Head and put the 4mm bar in it.
But the way with the cord is nice also, i need to test it
Hello Klaus. The spring should be tied to cord which then extends to the bottom of the PVC pipe. There it can be easily tightened or loosened to adjust for the centering tension.
Hi,
I am looking at your "Boeing 737 Single Yoke Control Head" design and I couldn't see any provision to pass through the head any cable from the Yoke to the column (elevator trim, push to talk, A/P Disengages, etc.).
Is this correct?
If so, what would you suggest as an alternative?
Thank you.
Best regards.
J.M.
Hey attached the spring to a 4mm Threaded Bar, which is attached into the middle of the Control head. I just make a 4 mm hole on both sides of the Head and put the 4mm bar in it.
But the way with the cord is nice also, i need to test it
Hello Klaus. The spring should be tied to cord which then extends to the bottom of the PVC pipe. There it can be easily tightened or loosened to adjust for the centering tension.