Are there plans available to make the wooden base into which the single yoke is installed? I see it pictured but it's not part of the plans i downloaded. Thank you!
I made a simple base. Mine is 12”x10” by 8” high. The top hole is 3 ½” from the end and 1 ½” from the top. It is 7/8” (20 mm) in diameter. The two pieces of wood at the bottom are to hold the potentiometer. More below about this. The bottom hole is 3 ½” from the end and 1 1/8” from the bottom, 3/8” in diameter.
I made a simple base. Mine is 12”x10” by 8” high. The top hole is 3 ½” from the end and 1 ½” from the top. It is 7/8” (20 mm) in diameter. The two pieces of wood at the bottom are to hold the potentiometer. More below about this. The bottom hole is 3 ½” from the end and 1 1/8” from the bottom, 3/8” in diameter.
Hi Steve,
I found it here. Link:
https://www.737diysim.com/737-base-dimensions?origin=notification -> 737 control base plans (l/h sidebar)