Hello,
How close to the real dimensions are the throttle levers in the 3D printed 737 TQ?
The reason for my question is that I am building a throttle quadrant in MDF for my home cockpit and I am thinking about to use the 3D printed throttle levers in my build.
Cheers
Andy
Hello Andy,
The throttle levers are nearly mm perfect to the real thing. I think the width should be 60mm and mine ended up being 62mm. I was going to correct this at some point, then it turned out to be way too much effort for such a tiny dimension after everyone else had created the units.
Good luck with your build!
Kind Regards
Karl