I am about to embark on the 737 project and would like to get going with the MIP Support Structure. I have downloaded the .PDF file for this and also downloaded the Fusion 360 design for this too. I have reached out to a local CNC cutting service who have asked for the .DXF format for the structure only, however upon opening the file, it only give the full control panel and not the support structure. As i don't have any .DXF software i am unable to check.
Is there is a .DXF for the MIP support structure only? I have also downloaded the following Fusion 360 designs for putting together the Knee Panel Structure, Glareshield Structure, FMC Structure and also the Pedestal Structure. At this stage, i only need the .DXF files for the structures only so i can send off to a CNC cutting service and i will get onto the other parts further down the line.
One question from the CNC cutter company, can you give me some advise on the below
My default cutter is m diameter so all internal corners will have a 3mm radius or I can include a fillet to clear the corner if required.
Looking forward to getting going
Thanks
AB