recently I printed the LH Backplate. It went terrible due to the small bed and the support structure. My Questions is now if it would be possible to split the LH Backplate into two halfs too? Just like the RH Backplate...
Karl now has stl files for 2 parts for the left half and 2 parts for the right (face panels), so they can be printed flat. I think the LH backplate needs to be printed vertical
Karl now has stl files for 2 parts for the left half and 2 parts for the right (face panels), so they can be printed flat. I think the LH backplate needs to be printed vertical
i'm pretty sure there is a 3 section backplate specifically for smaller printers in the zip file