Hello Karl,
I'd like to know the WxDxH of the EFIS 3D Print and also AutoBrake Panel (w/o flaps servo)?
I'm attempting to create a custom panel / frame that will slide in / out from under a desk using drawer runners so I can save space. Before commencing further it would be good to know the depth of these two requested parts so I can confirm if my approach will work.
So far I observe 152mm (W) x 56.5mm (D) x 113mm (H) for the AutoBrake Panel (w/o flaps servo) from your MIP PDF. Is that still correct?
I will use the FMC design you've made and my FMC PCB, a custom 737 Radio Panel I found on Thingiverse (VHF 1 and 2, NAV1 only, XPDR) and then your EFIS and AutoBrake Panel. If there's enough space I may add the OVHD lights on to the panel.
Here's my take so far:

Thanks,
Jonathan.
Hi Karl,
Do you think it would be possible to design a panel like above (with a few more items) that is custom? Happy to pay of course.
Thanks,
Jonathan.