Hi guys.
Does anyone have the dimensions of the 737 Ipeco pilot seats?
There is very little information online.
There is a company based near Cardiff airport that sells used aircraft parts but each seat sells for about £10,000. They even cost £3000 to £4000 for a replica.
I would like to design and make them. I just need the dimensions .
I’m more than happy to share my design afterward. I think it will be helpful to everyone in the community.
thanks
Mark
Here are the dimensions of the Ipeco seats, hope it helps you, measurements are in cm
Hi Tom
This is great. Thanks for taking the time to help. Im guessing there will be a lot of people interested in these dimensions
Time to start panning a DIY seat! I will show you the results when I have a working seat
Im guessing you live in or near Cardiff. I live between Newport and Chepstow, in Caerwent. Small world!
Thanks again
Mark
Here are the Numbers Mark. A-4"; B-6"; C-16"; D-18"; E-18"; F-16"; G-15"; H-25"; J-15"-19" K1-16"; K2-12"; L-3"x1". Sorry about the delay - went to the pub after the game!! TC.
The Sketch is attached Mark and the actual measurments will follow shortly; busy watching the Leinster - Cardiff match for the next couple of hours!! TC.
Hello from snowy Canada!
I am going to be using some Honda seats and would also like to know what dimension is to the top-front edge of the seat cushion. That is, how high above the floor is the top of the seat cushion as shown in the attached. This would be a great help because I can't find this anywhere.
Thanks!
Rob
Hello Mark,
I have a pair of B737-300 seats in my sim, so what measurments exactly do you require? I also have a spare pair of independent J-rails on which any Car/Van seat can be mounted. I had two Martin Baker Nimrod seats fitted on them before I acquired the 737 ones! RGDs, Tom.