Hi Karl
[Noob Alert]
I bought the Ender 3 v2 and I have printed a bunch of small stuff from the MPC v5. But Im stuck at the Back plate Left. It doesnt sit in any direction on the 220mm plate.
Anyhoo, since I will be mounting this directly on a plywood I dont need the screw supports for the box. I tried to reverse engineer it in Blender (noob again) but couldnt do it. Could you please
Share a 220mm version of the LH plates (or)
Share a backplate version that doesnt involve the box
Thanks for your help in advance
~BV
Since its a faceplate, I reverse engineered a cut in Blender and then screwed in a new hole ;)
@Karl Clarke I think I found one thats unpositionable!! I dont think this one can go vertical either. Thoughts? 13 FACEPLATE LH.stl
Thanks Karl. So the RH I was able to fit. But the LH is just too big for the 220mm. Here is my screenshot from Cura
Good Morning, This question gets asked daily and i must ammend the guide to show this.
Have you tried the way the print guide shows the RH?
Printing it vertically with support accross the printer bed at 45 degrees.