Hi Karl and thanks for the good drawing for the rudder pedals
Just starting the print of two pedals. In the spare part list there is no specification for the 2 springs for the brake pedals, only the 4 springs for the rudder itself is in the part list. What recommandations do you have for the springs to the brake pedals?
L=35 mm, OD=10, Wire thickness: 1,2 mm??
Hello, Springs are very dependant on the person using them. For myself, all springs come from the Amazon assorted spring box. Its a good starting point, and usually they have the right spring size, but not the strength. I usually have to then search for a stronger unit. However, for this particular unit and the brake return spring, this did actually come from the assorted box. I dont have the pedals here any more to check.
Hopefully, someone else building can confirm what springs they used?
Kidn regards
Karl