Hi Karl Quick update from Scotland i now have the sim flying just added a 65"screen at the front and installed a smaller 50" capt side

That looks awesome. That is what I would like mine hopefully look like down the road. I think I have narrowed down my printer choice with the Cr10s Pro. I will be ordering it shortly. I will start with the mcp and work my way up. I have purchased the 360 fusion plans for mcp from Karl, but am having trouble figuring out how to make the switch/encoder for heading and bank angle. I've looked through the videos and website but cant seem to find instructions anywhere. Would you happen to know where I could find these?

Thanks in advance

Dan

My apologies. I found what I was looking for on the website. Will try to do a little better research from now on

Dan

@Karl Clarke hi Karl hope you and the family are well sir just started my overhead structure will be using your 3d prints for the eyebrows i will send you a picture of the completed prints when i have glued and painted them but here is a wee preview of progress so far i decided to go down this route as MDF in the uk is the price of a small car at the moment 😄

I'm also using x plane 11. Do you know if there's a different way to bring up the ND other then zhsi? I can't seem to make it work. Thanks

@birco hi i found that ZHSI works really well i did try XHSI and had loads of problems configuring it to work

@Joey Jackson hi and thankyou for your comments i went a different way i am using xplane 11 for the sim and simvim for the cockpit along with ZHSI for the main cockpit screens all on two pc's