Hey Karl, pay close attention when printing with the .8mm nozzle, if your bed is not adjusted just right ,the filament will get a little squished which will throw off your dimensions a bit. You may then have to adjust the" Z" babystepping while printing your brims. Nothing a little sandpaper can't handle though.
Hey Karl, pay close attention when printing with the .8mm nozzle, if your bed is not adjusted just right ,the filament will get a little squished which will throw off your dimensions a bit. You may then have to adjust the" Z" babystepping while printing your brims. Nothing a little sandpaper can't handle though.
Good Morning sir!
Good Morning Louis from Brunei!