Boeing 737 Dual Controls!

4 Months of building! Countless hours of design and redesign. I am over the moon and super happy to show you this first prototype in action.


My first fully 3D printed (less hardware) Boeing 737 Dual Controls. Both axis now work. Yesterday saw the completion of the roll axis. Today saw the pitch lane design work for first time. I was worried that the plastic parts would not be able to withstand the loads required, but that proved unfounded.


It's a little janky right now due to the early design process! but now I can go ahead and make everything permanent. I also need a much smaller actuator!


It's late here in Brunei and it's been a full-on day! Now time to chill and finish up the design ready for tomorrow.


591 views4 comments

+673 7207616

Patreon:        737DIYSIM

YouTube:      Heli Mech

Facebook:    Boeing738v2

Instagram:    737DIYSIM

Twitter:         737DIYSIM

Watsapp:     +673 7207616

Email: HelenWatersClarke@Hotmail.com

Postal Address:

Karl & Helen Clarke

7 FLT AAC,

Medicina Lines

London

UK

BFPO 11

Fancy helping the website

or buying us a thank you beer?