And don't forget to select "Inclusive" in experimental. That's very important also.

I don't know what slicer program you use, I use Cura. In the Walls section I use "Print Thin Walls" and in the experimental section I use "Inclusive". All with a 0.2" nozzle and they turn out fantastic. The only downfall is it takes about 5 times longer to print.

Thank you so much Karl. I greatly appreciate this as I know you are busy moving. Again, thank you so much during this hectic time in your life. Regards Kevin

Anybody know if I can print just one button by itself. There always seems to be the same one button that does not print correctly

Thank you for your reply, Karl. Yes, the text shows up quite clearly in Cura. I will try to print them out again after I receive the 0.2mm nozzles tomorrow. If that does not work I will purchase them from you when you start selling them. Kevin

Thank you for the reply. I have just ordered some 0.2 nozzles. They should arrive on Sunday. I will try your recommendation. It just seems funny that the buttons with text printed fine for the G1000 panel.

I have a laser cutter/engraver for 2 years now. Unfortunately my shop is so overcrowded that I don't have room for it so it is still in the box. I have been using the hell out of my 3-D printer for all kinds of flight simulator things. Hopefully I will make some room for my laser cutter in the near future.

It's beautiful. Thank you so much. Greatly appreciated!

@kmoreyfolsom I have one other question. What Arduino Shield do you use to connect wires?

Thank you so much, Karl. I will order my clones now and be happy!

Never mind. I figured it out.