top of page

Garmin G1000 & G1000 NXI

This page is split into three main sections:

​

Parts Guide

Print Guide

Build Guide

​

​

​

The ultimate printer I can recommend is the Bambu Labs X1 carbon with AMS or P1P if you have deep pockets. ($1200). It's a massive leap forward in 3D printing, with excellent quality and impressive speeds. It's pretty much press print and go as the software and hardware do the calibration before each print. 

​

pilot sign get here.png
737 SINGLE YOKE HEAD.jpg

This design was primarily created with MSFS2020 in mind. The G1000 can be printed on a standard Ender 3 print bed of 220mm x 220mm. For improved quality, the buttons can be resin printed, but a filament printer will work fine too.

General Information:

Pilot Spanner.jpg

Build Guide

Build Guide
bottom of page