
737 Pilots Seat Base
This page is split into three main sections:
Parts Guide
Print Guide
Build Guide
The ultimate printer I can recommend is the Bambu Labs X1 carbon with AMS or P1P if you have deep pockets. ($1200). It's a massive leap forward in 3D printing, with excellent quality and impressive speeds. It's pretty much press print and go as the software and hardware do the calibration before each print.

⚠ WARNING: EXPERIMENTAL PROTOTYPE
This replica 737 IPECO/Weber-style pilot seat is an untested experimental prototype. It has not been structurally, fatigue or load tested and is not a certified or approved seating system.
Component failure could result in serious injury.
The replica seat mechanism contains moving and load-bearing components capable of creating severe crush, trapping and pinch hazards. Never place fingers, hands, limbs or other body parts between the upper and lower sections or within the moving mechanism.
The current 3D-printed design is intended for prototype/development purposes. The final concept is intended to use machined metal for appropriate structural components.
Anyone choosing to manufacture, assemble, modify, test or use this design does so entirely at their own risk and is responsible for assessing the suitability and strength of the completed assembly.
737DIYSIM accepts no responsibility or liability, to the fullest extent permitted by law, for injury, death, damage or loss arising from the manufacture, assembly, modification, testing or use of this design.
NOT FOR AIRCRAFT OR SAFETY-CRITICAL USE.
IF YOU DO NOT ACCEPT THESE RISKS, DO NOT BUILD OR USE THIS DESIGN.
General Information:
