737SS Knee Panel
This page is split into three main sections:
Parts Guide
Print Guide
Build Guide
The ultimate printer I can recommend is the Bambu Labs X1 carbon with AMS or P1P if you have deep pockets. ($1200). It's a massive leap forward in 3D printing, with excellent quality and impressive speeds. It's pretty much press print and go as the software and hardware do the calibration before each print.
General Information:
Build Guide
Click on image for more details
STEP:
1
Install a 4mm Internal Diameter (ID) x 5mm Outer Diameter (OD) x 5mm length heat insert into each orifice marked with a triangle next to it.
Click on image for more details
STEP:
2
Repeat the insert installation to parts KP11 to KP13 where a triangle is located on each of the surfaces.
Click on image for more details
STEP:
3
Continue the heat inserts for the Braces KP17, once again installing the insets where a triangle is marked.
Click on image for more details
STEP:
4
Place KP10 and KP11 together
Click on image for more details
STEP:
5
Using QTY 5, M4 x 12mm, countersunk screws attach the two parts.
Click on image for more details
STEP:
6
Do not place a screw where the 'X' is marked.
Click on image for more details
STEP:
7
Place kP11 and KP12 together
Click on image for more details
STEP:
8
Using QTY 5, M4 x 12mm, countersunk screws attach the two parts.
Click on image for more details
STEP:
9
Place KP12 and KP13 together
Click on image for more details
STEP:
10
Using QTY 5, M4 x 12mm, countersunk screws attach the two parts.
Click on image for more details
STEP:
11
Place the brace KP17 into the location on KP10. Alight the dual holes in the parts.
Click on image for more details
STEP:
12
Secure the Brace to the assy using QTY 2, M4 x 8mm countersunk screws.
Click on image for more details
STEP:
13
Repeat for the remaining 3 braces
Click on image for more details
STEP:
14
The assy should now look like this, it can now be placed to the side.
Click on image for more details
STEP:
15
Its time to construct the knee panel rail
Click on image for more details
STEP:
16
Insert Heat inserts into the parts marked with a triangle next to them.
Click on image for more details
STEP:
17
Place KP14 into KP15
Click on image for more details
STEP:
18
Secure the parts with QTY 2, M4 x 8mm countersunk screws
Click on image for more details
STEP:
19
Insert KP16 into the KP 15
Click on image for more details
STEP:
20
Secure with QTY 2, M4 x 8mm countersunk screws.
Click on image for more details
STEP:
21
Secure the knee panel rail to the assy with QTY 6, M4 x 22mm Screws