737SS AntiSkid Switch
This page is split into three main sections:
Parts Guide
Print Guide
Build Guide
The ultimate printer I can recommend is the Bambu Labs X1 carbon with AMS or P1P if you have deep pockets. ($1200). It's a massive leap forward in 3D printing, with excellent quality and impressive speeds. It's pretty much press print and go as the software and hardware do the calibration before each print.
General Information:
Build Guide
Click on image for more details
STEP:
1
Insert the Rotary switch (45 degree/8 position D-Shaft) Into AS1. Ensure the locating tang enagages with the orifice in AS1.
Click on image for more details
STEP:
2
Secure the switch with its supplied nut
Click on image for more details
STEP:
3
Insert an M4 x 30mm screw into AS1. Screw it in until it sits flush with the end of the mount
Click on image for more details
STEP:
4
Place the AS2 shaft onto the rotary switch
Click on image for more details
STEP:
5
Place the spring onto the shaft
Click on image for more details
STEP:
6
Place an M8 washer over the shaft until it sits on the end of the spring.
Click on image for more details
STEP:
7
Turn the rotary switch to the 4th position and tighen the screw until it meets the operating lever.
Click on image for more details
STEP:
8
Place the AS3 case over the unit.
Click on image for more details
STEP:
9
Secure the AS1 mount assembly to the AS3 Case with QTY 3, M4 x 10mm screws.
Click on image for more details
STEP:
10
Please refer back to the AUtobrake panel build guide:
https://www.737diysim.com/build-guides-1/737ss-autobrake-panel